Mercedes AMG: Engine Build Challenge


During my visit to Mercedes AMG before Christmas, the company set us a challenge that’s been put to other more notable visitors. In the engine build area, two engines were arranged in each bay, but without the coil pack, heat shield and exhausts fitted. Our task was to fit these parts to one side of the engine, along with tightening each fastener to the correct torque setting. A dozen journalists attended the day, the challenge being made even greater as the two current Mercedes AMG drivers had also previously completed the challenge.

The coil pack is handed over and the challenge starts...

The first job was to fit the coil pack. The four-pronged carbonfibre cased unit is a press fit atop each spark plug, then the we needed to connect CAN electronics interface near the front of the airbox.

Next the heatshield goes on... (eventual challenge winner watching intently behind)

A small reflective coated carbonfibre heatshield goes over the coil pack, attached with three small bolts, one of which is smaller and requires a different torque setting.

Access to the 24 exhaust studs under the engine was surprisingly good

Then onto the exhaust system, weighing about 3kg each exhaust is hand made from thin sections of inconnel welded together. Although the 4-into-1 exhaust is one assembly, there is some play in the primary pipes joints with the collector, so fitting the four exhaust pipes to the studs on the engine requires a little fiddling. Each exhaust pipe bolts to the exhaust port with three nuts, two above and to the side of the exhaust pipe, and one centrally below.

A blur of hand movement gets each nut threaded on...

Each of these 24 nuts being tightened to the same torque setting. With the engine up on the stand and being able to kneel below the engine, getting access to each fastener was surprisingly easy, none of the exhaust pipes being particularly obstructive. I’m sure doing the same job with the engine in the car and the floor fitted is a very different story.

A quick check that each nut is torqued correctly and the job's done.

I completed the challenge in 4m 30s and I was satisfied I’d done a good job. However ex Racecar Engineering magazine editor, Charles Armstrong Wilson completed the challenge in an impressive 3m 30s! Even though one (un-named) journalist took as long a 7m 57s, as group us journalists were confident we’d done a good job. But the teams Drivers had soundly beaten us all. Nico Rosberg did the challenge in 3m 15s, while Michael Schumacher did it thee minutes dead!

The job of the F1 engine builder and mechanic is a difficult and skilled one, the skills of the F1 driver are ever impressive and I’ll stick to drawing racecars and not working on them!

8 thoughts on “Mercedes AMG: Engine Build Challenge

  1. Awesome write up Craig… love it. As an avid follower of your blog, I have to say my understanding of F1 cars and their engineering has increased ten-fold in the last year or so. Keep up the good work!

  2. Great job, however would this have been a great opportunity to invite both fans and journo’s. This would of been an amazing opportunity to help fans get close to f1. Typical F1.

  3. Give Mercedes a break! You can’t really have heaps of people traipsing through your facility…..
    I think it was a great concept, helping to bring F1 a little closer to us. So Craig, you making the trip out here to Melbourne this year?

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s